« previous next »
Pages: [1]   Go Down

Author Topic: Hard Drive Set type error, ec=1022  (Read 77985 times)

dragan

  • Guest
Hard Drive Set type error, ec=1022
« on: October 18, 2007, 01:42:57 pm »
When I try to upload the project I get the error messagge:

Hard Drive Set type error, ec=1022

I have WebCat Plus ARM-E with 1 mb data flash on-board memory. I downloaded WebCat Publisher from Bipom.com site. Can anyone help with this error message please?
« Last Edit: October 18, 2007, 01:45:11 pm by dragan »
Logged

vitaliy

  • Full Member
  • ***
  • Posts: 30
    • View Profile
Re: Hard Drive Set type error, ec=1022
« Reply #1 on: October 19, 2007, 02:30:18 pm »
did you download webCatPlus firmware to the board ?
Logged

dragan

  • Guest
Re: Hard Drive Set type error, ec=1022
« Reply #2 on: October 25, 2007, 02:09:03 pm »
Yes, I did and I made sure it is right one (1MB, COM5, MM/ARM-E, Data Flash). I even tried it on two systems and I still get the same error. So, I am able to download firmware, but not the project. :(
« Last Edit: October 25, 2007, 03:08:49 pm by dragan »
Logged

vitaliy

  • Full Member
  • ***
  • Posts: 30
    • View Profile
Re: Hard Drive Set type error, ec=1022
« Reply #3 on: October 29, 2007, 01:54:51 am »
Please describe all your steps in details.
Logged

dragan

  • Guest
Re: Hard Drive Set type error, ec=1022
« Reply #4 on: November 05, 2007, 09:59:07 am »
Sorry I did not respond sooner, been busy. I think I found what causes the problem. Since none of the systems that I tried uploading the project did not have the serial port, I had to use USB-Serial adapter. Once I tried it on a older system with serial port on -board, it worked fine. I am still puzzled on why it would upload firmware, but it would not the project!
Logged
Pages: [1]   Go Up
« previous next »