BASCOM/Micro-IDE problem. How does one not use the simulator? I cannot simply remove it from the project settings because the only other choice is the MinMax/51C Debugger. I am trying to force running on the target board for two reasons: 1. It causes shutdowns with an error and 2. Checking the check mark to run on target board doesn\'t always force it to happen.
Project settings are:
Build - Bascom 8051
Download - MINI-MAX/51-C Loader
Debug - 8051 Simulator
Mfg. ID - Generic
Chip ID - 8052
Additional question in Micro-IDE forum about shutdowns.
